The unit straight shape ball joint rod end bearing SQZ...RS consists of ball joint rod ends with a ball stud attached, assembled in 180 degree position, and it is with lubricant inside and covered with a rubber seal, which features self-alignment and easy installation. These linkages with seal have a seal to keep lubricant in and dirt out.

The ball joint housing is an axial shank with a female thread, it’s made of zinc base alloy and they are available for right or left-hand female thread. The stud is machined to fit perfectly inside its housing and swivel in all directions—good for clutches, throttles, and shift control rods. Periodic lubrication may be required to keep them operating smoothly. This unit series is able to stand up to frequent use, these linkages offer excellent wear resistance.  

Application

The ball joint bearings are usually used in pneumatic components, bus doors, packaging equipment, agriculture equipment etc.