Selection summary of the form and specification of seated rolling bearing
Suitable for various purposes, various forms and specifications of seated rolling bearings have been serialized. Therefore, when choosing a seated bearing, it is necessary to fully grasp the mechanical structure, operating conditions, environment, etc. and perform a comprehensive analysis on it. The summary of the selection of the form and specification of the seated rolling bearing is shown in Chart 3.2. Table 3.2 Summary of the selection of the form and specification of the seated rolling bearing. Distinguish the required performance. The bearing specification is applicable to the use condition of the bearing box and the fixed seal structure of the shaft. , FL, FS, HA, IP, P, PA, PH, T, TH, TL, TU Eccentric fixing ring NA 1) ○ C, FC, NF, NFL, P, T Dustproof and waterproof stop screw fasteners Triple seal UC-L3UK-L3 ○ C, F, FA, FB, FC, FL, FS, HA, IP, P, PA, PH, T, TH, TL, TU Purification stop screw oil seal SU × FL0, P0 Corrosion-resistant stop screw oil seal + slinger UC-S6Y2. Y7Y1.Y2.Y3 ○ SFL-H1, SP-H1 Heat-resistant and cold-resistant high-speed blower oil seal + slinger UCUK○C, F, FA, FB, FC, FL, FS, HA, IP, P, PA, PH, T to distinguish the required performance, bearing box specifications, applicable bearing type, use condition, form mark material, whether or not dust cover can be oiled vertical seat PPsc ○ ○IP narrow Lightweight PA ○ UC (-L3) PH cast iron × ○ UC (-L3) LP × SB P0 ○ ○ × SUSP-H1 ○ UC-S6PP × × × SB flange type square corrosion-resistant tape Boss (square) (round) FSF-H1FSFC cast iron stainless steel cast iron cast iron ○ ○UC (L3), UK (L3) UC-S6UC (L3), UK (L3) UC (L3 ), UK (L3) diamond axis Adjustment (deformed rhombus) on one side (deformed) FLFA cast iron ○××○ UC (-L3) FB light weight (diamond) purification (diamond) corrosion resistance (diamond) LF × SBFL0 ○ × SUSFL-H1 ○ ○ UC-S6 steel plate Made (round) (diamond) PF steel plate × × SB. Choose from the perspective of maintenance. Rolling bearing slider seat with seat General T cast iron ○ ○ UC (-L3), UK (-L3) Strip steel frame T cast iron ○ ○ UC (-L3) Channel steel frame TL cast iron ○ ○ UC (-L3), UK (-L3) TU with steel plate frame PT H steel plate × × SBNPTH ring seat general C cast iron × ○ UC (-L3), UK (-L3) bracket seat general HA cast iron × ○ UC (- L3) Differentiate requirements, performance, bearing box specifications, applicable bearing form, use conditions, form mark, whether or not dust cover can be used for oil bearing housing, rolling bearings from the perspective of their structure, do not require maintenance for general purposes, but in important machinery And when used under special conditions, regular maintenance must be carried out. Therefore, in order to extend the interval of regular maintenance and shorten the maintenance man-hours, it is also very important to select the most suitable rolling bearing with seat according to the purpose and use conditions. In applications where there are vibrations and shocks, improve the life of the bearing and the strength of the bearing box; use stepped shafts in applications with large axial loads; use triple seal products and products with dust caps in dust and muddy environments ; In the use of working under high and low temperature conditions, fully study the material of the oil seal and the grade of the grease.