The 37-year angular contact ball bearing manufacturer's master summed up the factors affecting the bearing life

The life of the bearing is affected by many factors. The 37-year-old angular contact ball bearing manufacturer has summarized the following experience for everyone: 1. The pairing method of angular contact ball bearings is incorrect, and the service life will be affected; If they are paired in series, they can only accept axial loads in one direction, while back-to-back combinations can withstand axial loads in two directions and provide higher rigidity, while face-to-face combinations can also withstand axial loads in two directions. But the rigidity is not as good as the back-to-back combination; 2. Don't use those angular contact bearings whose raw materials are of poor quality; the life of angular contact ball bearings is closely related to the raw materials, and the content of other elements in the steel is slightly different, which will cause a huge performance. Therefore, high-quality raw materials will strictly control the content of carbon, silicon, manganese, phosphorus, sulfur and other elements in it, so as to improve the toughness and contact life of the steel as much as possible. Maintenance work; First of all, when the bearing is stored for a long time, it is best to be in an environment with a temperature of 20°C and a humidity of less than 65%, and it is advisable to place it on a shelf 30cm above the ground; secondly, during the use of the bearing, it is necessary to stop regularly Inspection, check whether the bearing seal is damaged, whether the lubricant is sufficient and clean, and finally, it is also very important to keep the working environment clean and tidy; 37 years of angular contact ball bearing manufacturers, specializing in the production of angular contact ball bearings, deep groove ball bearings, roller bearings, There are four types of needle roller bearings, the size range is up to 450mm in outer diameter, and the inner hole size is above 10mm. Matching, professional customization. The torque is accurate, in order to turn stable!