Many people find in production that the bearing accuracy of the grinder decreases, so what are the reasons for the decrease in the accuracy of the spindle bearing of the grinder? In fact, there are many reasons that lead to the decrease in the accuracy of the grinding machine spindle bearing: it may not be installed properly, the bearing accuracy may not be good, the bearing may not be adjusted properly, it may need to be run-in, and so on. In fact, each part has errors, and the maintenance of high precision is a systematic, not independent, even if all parts have high precision, it may not be able to achieve very high precision, because the errors can be accumulated; conversely , even if all the parts are not very accurate, if they are designed and installed correctly, they can achieve very high accuracy, even higher than the parts with high accuracy; because the error can also be offset. Let's talk about the installation and disassembly of the grinding machine spindle bearing: there are certain principles for structural installation and disassembly. For example, when disassembling the machine tool spindle, some people will choose to disassemble them all before reassembling, and some people will disassemble them modularly. And assembly, some people like to use brute force, some people like to use special tooling; especially when disassembling the bearing, the accuracy of the spindle has been destroyed when it is disassembled, and the accuracy must be restored when it is installed. Practices include re-grinding the installation position, selecting bearings with small errors, multiple bearing displacements, and so on. Let's talk about the installation of the grinding machine spindle bearing: most of the bearings and the shaft are over-fit, what is the temperature range that the shaft and the bearing are subjected to, and the temperature control of heating and cooling is very important. Finally, consider the shell, load-bearing parts and deformation caused by ground subsidence, etc. This is why your grinder becomes less accurate. The torque is accurate, in order to turn stable!