In the process of applying the full complement bearing.com/cylindrical-roller-bearings.html' target='_blank'>cylindrical roller bearing, if you do not pay attention to the small details, it will also affect the application of the bearing, which will cause the lubrication condition of the bearing, and there are doubts about the temperature, so you should start from the following Considering one aspect, the bearing will have obvious rotating sound during the application process. This may be due to the slight damage, so there will be irregular sound, which needs to be checked in real time. In addition, during the application of the bearing, the full complement cylindrical roller bearing will also cause damage to the bearing due to the phenomenon of vibration, and all these can be inspected. How big the vibration result is, and then you can infer whether there is an abnormality, and finally make a selection based on the conditions of the application. At the beginning, you need to test each different machine, and then you can know the exact calibration standard after the test. , because after inspection, it can be seen that there are obvious indentations or cracks. In addition, when using the bearing, it is also necessary to pay attention to the temperature of the bearing. If the oil hole can be used, you can simply check the current temperature of the bearing and whether the temperature is suitable, because in the process of operation, the temperature of the bearing will gradually increase. It may take 1-2 hours to upgrade and enter a stable state. The normal temperature of the bearing is relatively tight, and once a very high temperature occurs, it will be damaged at any time. (1) Use the ball screw in a clean environment. Use together with a dust cover, etc., to prevent dust and dust from entering the ball screw. If dust and shavings enter the ball screw due to poor dustproofing, it will not only aggravate the decline in the performance of the ball screw, but also occasionally cause blockage due to dust, etc., which will damage the circulating parts and cause tensions such as lack of workbenches. Confusion. (2) For the number of applied revolutions, please refer to the items related to the allowable revolutions recorded in this product brochure and the product specification confirmation chart of our company. If it is used under the condition of exceeding the allowable number of revolutions, it is easy to damage the circulating parts and cause the hazard of the workbench. When the vertical axis is used, it is recommended to configure safety nut and other protective mechanisms to prevent the lack of workbenches. For incidents related to the protection organization, please consult with our company. (3) If the ball screw nut is used for overtravel, there will be disadvantages such as lack of balls, damage to the circulating parts, and indentation of the track, resulting in poor operation. Continued use under this condition will result in accelerated wear and damage to recurring parts. So please do not overrun the application. If there is an over-travel application, please ask our company for inspection, and our company will provide a paid method for inspection. (4) The design application temperature limit of this product is below 80 degrees, please do not use it under this temperature condition. Otherwise, it may cause damage to the revolving parts and sealing cover parts.
Wow, this sounds like a bit of a cruel question, but it is a vitally important question to ask yourself if you are struggling with your Bearing Suppliers and you would like to stop the CONTACT US problem.
Dazzle your next event with Hrb Bearing China CONTACT US and to buy best product， only trust HangZhou Jnsn Bearing Imp& Exp Co., Ltd.
HangZhou Jnsn Bearing Imp& Exp Co., Ltd’s model also predicts (i) a positive effect of management on firm performance; (ii) a positive relationship between product market competition and average management quality (part of which stems from the larger covariance between management with firm size as competition strengthens); and (iii) a rise (fall) in the level (dispersion) of management with firm age.