Improper disassembly of the vibrating screen bearing may cause internal damage to the bearing. Contaminants may enter the bearing or errors may occur during reinstallation. Therefore, you must be very careful when disassembling the vibrating screen bearing, and the shaft must be properly supported, otherwise the disassembly force may damage the bearing.　1. Disassembly of the periphery 　Remove the outer ring of the interference fit, and set several screws for extruding the outer ring on the circumference of the outer ring in advance, and tighten the screws evenly on one side. Disassemble on one side. These screw holes are usually covered with blind plugs and separable bearings such as vibrating screen tapered roller bearings. Several cuts are set on the housing shoulders. Use spacers to remove them with a press or gently tap them to remove them.　 2. The disassembly of the cylindrical bore bearing of the vibrating screen 　 The disassembly of the inner ring can be pulled out by a press machine. At this time, pay attention to let the inner ring bear its pulling force.　 The inner ring of the large-scale vibrating screen bearing is disassembled by oil pressure. Oil pressure is applied through the oil hole provided on the shaft to make it easy to draw. For bearings with a large width, the hydraulic method and the drawing fixture are used together for disassembly operations.　 NU type, NJ type cylindrical roller vibrating screen bearing inner ring can be disassembled by induction heating method. It is a method to heat the part in a short time to expand the inner ring and then pull it out.　 3. Removal of the tapered bore bearing 　 Remove the relatively small bearing with adapter sleeve, support the inner ring with the stopper fastened on the shaft, turn the nut back several times, and use the spacer to knock it off with a hammer.